Installing A Simple-Swap Hard Disk Drive; Installing An Optional Hot-Swap Rear Hard Disk Drive Cage - IBM x3630 M4 Type 7158 Installation And User Manual

Installing a simple-swap hard disk drive

Note: You must turn off the server before installing simple-swap drives in the
server.
To install a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii, "Installation guidelines" on
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. If installing a new drive, touch the static-protective package that contains the
4. Remove the filler panel from the front of the server.
5. Gently push the drive assembly into the drive bay until the drive clicks into
6. Reinstall the filler panel that you removed.
7. Turn on the peripheral devices and the server.

Installing an optional hot-swap rear hard disk drive cage

56
System x3630 M4 Type 7158: Installation and User's Guide
page 35, and "Handling static-sensitive devices" on page 37.
cords; then, disconnect all external cables as necessary to replace the device.
new drive to any unpainted metal surface on the server; then, remove the drive
from the package and place it on a static-protective surface.
place.