Rotating the optional hot-swap rear hard disk drive cage down
Read the safety information that begins on page vii and "Installation guidelines" on
page 35.
To rotate the optional hot-swap hard disk drive cage down, complete the following
steps.
1. Shift the switch on the rear hard disk drive cage to the unlock position 1 .
2. Slowly rotate the cage downwards until it sits into place 2 .
3. Close the blue latches on the chassis 3 .
Installing the server top cover
To install the server top cover, complete the following steps:
1. Make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
3. Slide the cover forward toward the front of the server until the cover is
edges slip into position over the chassis.
Attention:
Before sliding the cover forward, make sure that all the tabs on
both the front, rear, and side of the cover engage the chassis correctly. If all the
tabs do not engage the chassis correctly, it will be hard to remove the cover
later.
completely closed.
Chapter 2. Installing optional devices
93