Display Control Panel Features - Star Trac 4500 Owner's Manual

Operating the §TAR TRAC 4SDD TREADMILL is very easy. Simply step onto the running
belt, press and begin walking or running naturally.
START
Learning the features and incorporating the §TAR TRAC 4SDD TREADMILL into your
members' fitness programs is just as easy. In this chapter, you will learn the display function and
how to get the most out of every §TAR TRAC 4SDD TREADMILL workout.
D/§PLAY CONTROL PANEL FEATURE§
Your §TAR TRAC 4SDD TREADMILL is equipped to provide you and your users unlimited
exercise opportunities. Experiment with its features to find the right combination for your fitness
regirmen. The Display Control Panel shown on the opposite page features:
Key: Starts your treadmill running belt moving. Enters and confirms your workout duration.
START
Key: Pauses your treadmill when pressed once. Ends your workout when pressed twice.
Graphic Display: Traces your progress through each of the programs and allows you to antici-
pate the hills and valley. Display elements illuminate from left to right across the bottom of the
display to indicate your progress through the course. At each step, display elements illuminate in
columns to indicate your ascent up the gradient that is in effect. In Manual Operation this display
shows your progress counter clockwise around a 1/4 mile (400-meter) course, starting from the
bottom center.
I I
J
Keys: Adjust running belt speed in 0.1 miles per hour (mph) or 0.1 kilometers
per hour (km/hr) increments. To increase or decrease your speed, press the
tively, until the desired number ofminutes appears in the Alphanumeric Display, then, press
The speed cannot be higher than the MX SPD data item (See Chapter 6). If you do not press
within 15 seconds, the previous display will return. These keys repeat as you hold them depressed.
These keys also start the running belt at minimum speed from zero.
CHAPTER
or keys, respec-
START
START