6.8.7 METAL SCREEN
C267D946.WMF
The flow of ink is shown above. The excess ink goes back to the inside of the drum
from the trailing edge of the metal screen.
[A]
C267D947.WMF
The adhesive parts [A] are only at the sides of the mylar seal for the metal screen.
They are not attached to the trailing edge. This prevents ink leakage from the
trailing edge.
[B]
C267D948.WMF
The leading edge of the mesh on the metal screen is reduced by 2.5 mm [B] from
previous models. This prevents small dots at the leading edge of the paper.