Sp2-62: T/H Swing Amount; Sp2-80: Auto Off At Unusual Voltage; Sp2-95: Paper Table Standby Position; Sp2-100: Make Master Without Print - Ricoh C231 Service Manual

SP2-62: T/H SWING AMOUNT

5.3.7 SP2-62: T/H SWING AMOUNT
Settings: +-1 to +-5 mm
Default: 2 mm

5.3.8 SP2-80: AUTO OFF AT UNUSUAL VOLTAGE

There is an automatic detection system for unexpected voltage surges, featuring
automatic shut-off and data logging features.

5.3.9 SP2-95: PAPER TABLE STANDBY POSITION.

High: The paper table after printing is moved to a higher position than the standard
position. This will reduce the time for starting the first print when
continuously making masters.
Low: The standard position
NOTE: If SP2-95 is "high", the machine goes to the standard position in the
following situations.
• When the master end indicator lights and a message is displayed
• When a master eject jam (B jam location indicator) is displayed
• When a master feed jam (D jam location indicator) is displayed
• When the paper height sensor is actuated immediately after the main
switch is turned on.

5.3.10 SP2-100: MAKE MASTER WITHOUT PRINT

This function wraps a blank master around the drum. The ink on the drum may dry
up at the following times:
• The machine is not used for a long time.
• The customer changes to a color drum that has not been used recently.
This might affect the print quality (Poor image: ghost image of the previous print).
Wrap a blank master around the drum after you print, to prevent ghost images of
previous prints when the machine is not used for a long time.
Procedure:
1) Access SP2-100 (Make master without printing). Then press "OK".
2) Press the "Start" key while holding down the "#" key.
C267 5-6 SM