Section 1 -Getting Started; Ce Conformity (Europe) Notice - Honeywell ST 3000 Installation Manual

1.1

CE Conformity (Europe) Notice

About conformity and
special conditions
ATTENTION
2/05
Section 1 —Getting Started
This product is in conformity with the protection requirements of
89/336/EEC, the EMC Directive. Conformity of this product with any
other "CE Mark" Directive(s) shall not be assumed.
Deviation from the installation conditions specified in this manual, and
the following special conditions, may invalidate this product's
conformity with the EMC Directive.
• You must use shielded, twisted-pair cable such as Belden 9318 for all
signal/power wiring.
• You must connect the shield to ground at the power supply side of the
wiring only and leave it insulated at the transmitter side.
The emission limits of EN 50081-2 are designed to provide reasonable
protection against harmful interference when this equipment is operated in an
industrial environment. Operation of this equipment in a residential area may
cause harmful interference. This equipment generates, uses, and can radiate
radio frequency energy and may cause interference to radio and television
reception when the equipment is used closer than 30 meters (98 feet) to the
antenna(e). In special cases, when highly susceptible apparatus is used in
close proximity, the user may have to employ additional mitigating measures
to further reduce the electromagnetic emissions of this equipment.
ST 3000 Release 300 Installation Guide
ATTENTION
1