Configuration
Synchronizing with a Standard Time Server
You can set up time synchronization between the DVR and standard time servers that
are available in most time zones and countries, or between this DVR and another DVR.
1.
2.
3.
4.
The Last Sync-Time field displays the last time the DVR was synchronized with the time
server.
5.
6.
Storage Screen
Highlight Storage in the System menu and press
screen appears and displays information about the DVR storage devices.
42
Highlight the Time Sync. tab. The Time Sync. screen displays.
Figure 3-12
Time Sync. Screen
Highlight the field beside Automatic Sync. and press
and Off. When set to On, the Time Server and Interval fields become active.
Highlight the field beside Time Server and press
enter the IP address or domain name of the time server.
Note
You can use the domain name instead of the IP address if you
have already set up the DNS Server when setting up the LAN.
Highlight the field beside Interval and press
synchronization from 30 minutes to 1 day at various time intervals.
Highlight Run as Server and press
On, the DVR you are setting up runs as a time server.
Save your changes by highlighting Save and pressing
the screen without saving the changes.
to toggle between On
. Use the virtual keyboard to
. Set the time interval for
to toggle between On and Off. When it is
. Select Cancel to exit
. The Storage Information Setup