Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Sp Imp.); Selecting The Remote Control Id (Remote Id) - Yamaha RX-V775 Owner's Manual

Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
PROGRAM STRAIGHT
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.

ADVANCED SETUP menu items

Item Function
SP IMP. Changes the speaker impedance setting.
REMOTE ID Selects the unit's remote control ID.
(Asia and General models only)
TU
Changes the FM/AM tuning frequency setting.
TV FORMAT Switches the video signal type.
MON.CHK Removes the limitation on HDMI video output.
INIT Restores the default settings.
UPDATE Updates the firmware.
VERSION Checks the version of firmware currently installed on the unit.

Changing the speaker impedance setting (SP IMP.)

SP IMP. 8 MIN
Change the unit's speaker impedance settings depending on the impedance of the
speakers connected.
Settings
6 Ω MIN
8 Ω MIN (default)

Selecting the remote control ID (REMOTE ID)

REMOTE ID
Change the unit's remote control ID so that it matches the remote control's ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
automatically canceled.
Page
1
Press CODE SET on the remote control.
105
2
Press RECEIVER.
105
3
Use the numeric keys to enter "5019" (ID1) or "5020" (ID2).
106
Once the remote control ID is registered successfully, SOURCE blinks twice.
106
If it blinks six times, registration failed. Repeat from Step 1.
106
106
• The registered remote control codes (p.108) are not cleared even if you change the remote control ID.
107
107
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu)
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
Select this option when you connect 8-ohm or higher speakers to the
unit.
ID1
105
En