1 2
3 4 5 6 7 8 9 10
Speaker connections
7.1-channel system
(using presence speakers)
ZONE2/F.PRESENCE
The unit (rear)
SPEAKERS
FRONT
CENTER
SURROUND
SURROUND BACK/BI-AMP
CENTER
CENTER
1
2
SUBWOOFER
Q
1
2
9
3
4
6.1-channel system
EXTRA SP
The unit (rear)
CENTER
CENTER
SINGLE
1
2
SUBWOOFER
W
9
5
4
When using only one surround back speaker, connect it
to the SINGLE jack (L side).
EXTRA SP
ZONE2/F.PRESENCE
SPEAKERS
FRONT
CENTER
SURROUND
SURROUND BACK/BI-AMP
SINGLE
1
2
3
5
8
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminal.
a Remove approximately 10 mm (3/8") of insulation from
the ends of the speaker cable and twist the bare wires of
the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d Tighten the terminal.
c
F R
+ (red)
b
O N
T
a a
d
- (black)
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
a
F R
O N
T
Banana plug
b
PREPARATIONS ➤ Connecting speakers
20
En