Video; Video Mode - Yamaha RX-V775 Owner's Manual

■
Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5 dB
Default
+16.5 dB
■
Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
Sets the level to the volume level of the unit when it last entered
Off (default)
standby mode.
Sets at Mute or the specified volume level (-80 dB to +16.5 dB, 0.5 dB
increments).
On
(This setting works only when the initial volume is set lower than "Max
Volume".)
■
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level when the volume
is adjusted.
Settings
Off Does not adjust the effect level automatically.
On (default) Adjusts the effect level automatically.

Video

Configures the video output settings.
■

Video Mode

Enables/disables the video signal processing (resolution and aspect ratio).
Settings
Direct (default) Disables the video signal processing.
Enables the video signal processing.
Processing
Select a resolution and an aspect ratio in "Resolution" and "Aspect".
• When "Video Mode" is set to "Direct", the unit transmits video signals with the least circuitry in order to
reduce video output delay.
• When "Video Mode" is set to "Processing" and the resolution is being converted, short messages are not
displayed on the TV screen.
❑ Resolution
Selects a resolution to output HDMI video signals when "Video Mode" is set to
"Processing".
Settings
Through Does not convert the resolution.
Auto (default) Selects a resolution automatically in accordance with TV resolution.
480p/576p, 720p, Output video signals with a selected resolution.
1080i, 1080p, 4K (Only the resolutions supported by your TV are selectable.)
• If you need to select a resolution that is not supported by your TV, set "MON.CHK" (p.106) in the
"ADVANCED SETUP" menu to "SKIP" and try again. (Note that the output video may not be displayed on
your TV normally.)
CONFIGURATIONS ➤ Configuring various functions (Setup menu)
95
En