802�1X; Ip Address Filter - TRENDnet TV-IP310PI User Manual

TV-IP310PI User's Guide
802�1X
Setup 802.1X for remote authentication service.
802.1X Authentication
Enable IEEE Check this box to enable 802.1X authentication
802�1X: service�
EAPOL version: Extensible Authentication Protocol (EAP) over LAN
(EAPoL)� Choose version 1 or 2� This version number
much match to your 802�1X service EAPOL version�
User Name: Enter the account name�
Password: Enter the password�
Confirm: Enter the password again�
Click Save to save the changes�
© Copyright 2014 TRENDnet. All rights reserved.

IP Address Filter

Set up a list of clients allow only the clients on the list to access this
camera or to reject clients on the list from access this camera.
Enable IP Check this box to enable IP address filtering
Address Filter: service�
IP Address Choose Forbidden to ban the listed IP addresses or
Filter Type: Allowed to allow listed host to access this camera.
Add: Click Add to add a user account
Modify: To modify an entry on the list, highlight the entry
by clicking on it. Then, click the Modify button.
Enter the IP address then click OK�
Delete: To delete an entry on the list, highlight the entry by
clicking on it. Then, click Delete�
Clear: To clear all entries, click Clear�
Click Save to save the changes�
Network Settings
34