National Instruments DAQ PCI E Series User Manual page 154

PCI-MIO-16XE-10, PCI-MIO-16XE-50,
PCI-6032E, and PCI-6033E
actual range and measurement
precision (table), 3-8
unipolar and bipolar, 3-7
selection considerations, 3-8
installation
hardware, 2-1 to 2-2
questions about, C-2
software, 2-1
unpacking PCI E Series, 1-7
I/O connectors, 4-1 to 4-11
cable connectors for PCI E Series, 1-6
exceeding maximum ratings (warning),
4-1
I/O signal summary (table)
PCI-MIO-16E-1, PCI-MIO-16E-4,
and PCI-6071E (figure), 4-7 to 4-8
PCI-MIO-16XE-10, PCI-6031E,
PCI-6032E, and PCI-6033E
(figure), 4-8 to 4-10
pin assignments (figure)
50-pin analog input connector, B-5
50-pin E Series connector, B-4
68-pin E Series connector, B-2
68-pin extended analog input
connector, B-3
PCI-6071E, PCI-6031E, and
PCI-6033E (figure), 4-3
PCI-MIO-16E-1, PCI-MIO-16E-4,
PCI-MIO-16XE-50,
PCI-MIO-16XE-10, and
PCI-6032E (figure), 4-2
signal descriptions (table), 4-4 to 4-6
L
LabVIEW and LabWindows/CVI application
software, 1-3
© National Instruments Corporation
M
manual. See documentation.
MITE bus interface chip, 1-1
multiple-channel scanning, 3-10 to 3-11
N
NI-DAQ driver software, 1-3 to 1-4
noise, avoiding, 4-46 to 4-47
NRSE (nonreferenced single-ended input)
description (table), 3-5
differential connections, 4-18 to 4-19
recommended configuration (figure),
4-15
single-ended connections (NRSE
configuration), 4-21 to 4-22
O
optional equipment, 1-5
output characteristic specifications
PCI-MIO-16E-1, PCI-MIO-16E-4, and
PCI-6071E, A-6
PCI-MIO-16XE-10 and PCI-6031E, A-16
PCI-MIO-16XE-50, A-24 to A-25
P
PCI E Series. See also hardware overview.
custom cabling, 1-6
features, 1-1 to 1-2
optional equipment, 1-5
questions about, C-1 to C-5
analog input and output, C-2 to C-3
general information, C-1 to C-2
installation and configuration, C-2
timing and digital I/O, C-4 to C-5
requirements for getting started, 1-2
software programming choices, 1-2 to 1-5
ComponentWorks, 1-3
I-7
Index
PCI E Series User Manual