Volt Battery Installation - Power Wheels Super Talk! BARBIE Sun Jammer Owner's Manual With Assembly Instructions

G
Important Note: Use only Power Wheels
amp fuses installed. Use of any other 6 volt batteries or fuses may damage your vehicle. Make
sure that you charge the 6 volt batteries for at least 18 hours before operating your vehicle for
the first time. After first-time use, charge the 6 volt batteries for at least 14 hours after each use.
Never charge the 6 volt batteries longer than 30 hours. Failure to follow these instructions may
damage your 6 volt batteries and will void your warranty.
Seat Back
Battery
Compartment
Rear of Vehicle
Battery Connectors
Battery Retainer
Batteries

6 Volt Battery Installation

Canopy Not Shown
Power Wheels
®
Type H Batteries
Canopy Not Shown
Canopy Not Shown
® Type H (9.5 Amp/hr.) batteries with Power Wheels
Power Wheels
®
30 Amp Fuses
29
1
• Lift the seat back to access the
battery compartment.
2
• Place both Power Wheels
batteries upright in the battery
compartment directly on top of
the molded-in battery informa-
tion. Make sure the battery
connectors extend toward the
rear of the vehicle.
• Make sure a Power Wheels
30 amp fuse in good condition
is installed in each of the 6 volt
batteries and that the battery
connectors are snapped
together.
3
#8 x 3 / " Screw – 2
4
Shown Actual Size
• Position the battery retainer over
the batteries with the ends of the
battery retainer aligned with the
screw holes in the bottom of the
battery compartment.
• Insert two #8 x 3 / " screws through
4
the battery retainer and into the
battery compartment.
• Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
® 30
6 volt
®
®