Battery Compartment Door
Placing the "AAA" (LR03) batteries in the phone with the
positive (+) and negative (-) markings the wrong way could
cause damage or over-heating resulting in injury. The "AAA"
(LR03) batteries must be positioned as shown on the battery
compartment door.
Please Note:
• Do not mix old and new batteries.
• Do not mix different types of batteries; alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Remove batteries during long periods of non-use. Always remove exhausted batteries from this product.
Battery leakage and corrosion can damage this product.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type, as recommended above, are to be recharged.
• If removable rechargeable batteries are used, they are only to be charged under adult supervision.
• Rechargeable batteries are to be removed from this product before they are charged.
• If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until it has been properly repaired.
Assembly
Phone
WARNING
12
4
–
"AAA" (LR03) x 3
Shown Actual Size
#3 x
3
/
" Screw – 2
8
Shown Actual Size
• Open the phone's battery
compartment door and remove
the packet of #3 x
3
/
• Insert three "AAA" (LR03) alkaline
batteries as indicated in the
battery compartment.
• Close the battery compartment
door.
3
• Insert the #3 x
/
" screws into the
8
holes in the battery compartment
door and tighten the screws with
a Phillips screwdriver. Do not
over-tighten.
+
" screws.
8