Power Wheels Super Talk! BARBIE Sun Jammer Owner's Manual With Assembly Instructions page 26

Taillight
Housing
Taillight
Lens
Rear Bumper
Assembly
Tabs
Slots
Gas Cap Assembly
• Using safety scissors, remove the
• Face the rear of the vehicle.
• Fit a taillight lens inside a
• Position the taillight housing with
• Insert two #8 x 1" screws through
• Tighten the screws with a Phillips
• Repeat this procedure to attach
• Fit the tabs on the rear bumper
• Push down on the rear bumper
Right Taillight
Gas Cap
Tether
• Position the gas cap assembly so
• Snap the gas cap assembly
26
35
#8 x 1" Screw – 4
Shown Actual Size
taillight lenses and the taillight
housings from the plastic connec-
tors. Dispose of the plastic con-
nectors.
taillight housing.
lens against the vehicle body
with the screw holes aligned, as
shown.
the taillight lens and housing and
into the vehicle body as shown.
screwdriver. Do not over-tighten.
the other taillight.
36
into the slots in the vehicle body.
to fit the holes in the rear bumper
onto the pegs on the vehicle
body.
37
that its tether points down.
into the opening under the right
taillight.