Power Wheels Super Talk! BARBIE Sun Jammer Owner's Manual With Assembly Instructions page 25

Sport Bar
Support
PUSH HERE
Side
Fender
PULL HERE
Light Housing
Assembly
Sport Bar
Light Cover
25
33
1 / " x1 1 / " Screw – 2
4 2
Shown Actual Size
• Push down firmly on one side of
the sport bar while pulling up on
the vehicle body side fender to fit
the sport bar completely into the
vehicle body.
• Repeat this procedure on the
other side of the sport bar.
• Insert a 1 / " x 1 1 / " machine screw
4 2
into the hole closest to the front
ot the vehicle in the underside of
the rear wheel well, through the
vehicle body and into the end of
the sport bar.
• Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure on the
other side of the vehicle.
34
• Align the four tabs on the inside
of a light cover with the four slots
in one of the light housings on the
back half of the light rack.
• Push firmly on the light cover
to snap it to the light housing.
• Repeat this procedure on the
other side of the light rack to
assemble the other light.