Power Wheels Super Talk! BARBIE Sun Jammer Owner's Manual With Assembly Instructions page 19

Tabs
Slot
Tabs
1
2
Assembly
Hood
Slot
Windshield
Slots
1
2
19
19
• Position the hood over the front
of the vehicle body as shown.
• Insert the tabs on the hood into
the slots in the vehicle body.
• Close the hood.
20
• Insert the tabs on the windshield
into the slots in the vehicle body.
21
1
#8 x 1 / " Screw – 2
2
2
#8 x 1" Screw – 4
Both Shown Actual Size
• Rotate the windshield forward so
that the base of the windshield
lies flat against the dash.
• Insert two #8 x 1 / " screws into the
2
holes in the rear of the windshield
as shown .
1
• Tighten the screws with a Phillips
screwdriver. Make sure there is no
gap between the windshield and
the dash. Do not over-tighten the
screws.
• Insert four #8 x 1" screws into the
holes in the front of the wind-
shield .
2
• Tighten the screws with a Phillips
screwdriver. Do not over-tighten.