Assembly - Power Wheels Super Talk! BARBIE Sun Jammer Owner's Manual With Assembly Instructions

F
Do Not Omit Any Steps. Please set aside at least 60 minutes for assembly.
18
13
21
TM
Key Chain
Key
Square
Opening
Key Chain
Key Assembly
Dash
Phone Holder

Assembly

Dashboard Plate
19
20
13
Knobs
Tab
15
Knob Plate
Phone Clip Holder
11
1
• Apply labels to the dashboard
plate, knob plate, and both sides
of the key chain as shown. Make
sure the areas where the labels
will be applied are clean and
dry. For best adhesion, avoid
applying labels more than once.
2
• Snap the key assembly into the
dashboard plate.
• Insert the key chain end through
the key and then into the square
opening in the key chain.
• Snap the knobs into the knob
plate.
Note: Gently squeeze the tabs on
the knobs together before insert-
ing the knobs into the knob plate.
• Set the dashboard plate and
knob plate aside.
3
#6 x 1" Screw
Shown Actual Size
• Fit the phone holder into the
pocket in the dash, as shown.
• Slide the tab on the front of the
phone holder clip into the slot in
the bottom of the phone holder
to secure the phone holder to
the dash.
• Insert a #6 x 1'' screw through the
top of the phone holder and the
dash, and into the screw peg on
the back of the phone holder
clip, as shown.
Helpful Hint: Press on the screw
peg to align it with the screw
holes in the phone holder and
dash.
• Tighten the screw with a Phillips
screwdriver. Do not over-tighten.