Setpoint Only Display; Weekly Operating Schedule Forms - Trane X1379088401 Installation, Operation And Maintenance Manual

Operation

Setpoint Only Display

You can configure the zone sensor to present setpoints instead of the space temperature on the
main display. To display setpoints instead of space temperatures, follow these steps:
1. Begin at the home screen
2. Press the
3. Press
4. To return to showing space temperature on the display, press the
Figure 6. Setpoint only display
Indicates that setpoints
are on display and not
space temperature

Weekly Operating Schedule Forms

The easiest scheduling procedure is sequential. You should complete the schedule setup for each
period of the day, in order, before you move on to the next day. For instance (refer to
below), once the schedule is opened, you will start with Monday and the Morning period (1). Set
the start time, occupancy, heating and cooling setpoints, and fan operation if applicable. Once you
finish with the morning period, you will complete the Day period (2)(same settings as for
Morning...start time, occupancy, etc.). You should complete all available periods for Monday before
moving on to Tuesday (5). The same rules apply for Tuesday. Each period should be set in order
before moving on to Wednesday. This applies to all days in the schedule.
Figure 7. Sequential completion of a weely operating schedule.
You can use
HP units. For sensors configured as VAV, see
24
and
instead of the space temperature. Setpoint presentation is indicated by an arrow in the upper
left corner of the display (see
or
to toggle between the heating and cooling setpoints.
simultaneously for four seconds.
Table 5, p. 25 to create a weekly operating schedule for sensors configured for CV or
simultaneously for four seconds. The active setpoint now appears
Figure 6).
Table 6, p.
and
26.
Figure 7
BAS-SVX17B-EN