Using Forms Adjust - Intermec 3400 User Manual

3400, 3440, and 3600 Bar Code Label Printer User's Manual
7. To enable 10 mil emulation, turn on DIP switch 4 and turn off DIP switch 5.
8. Press the Feed/Pause button.
9. Turn the printer off and then on.
10. Download the 86XX formats, fonts, and graphics from the host to the

Using Forms Adjust

If your label prints too close to one edge, you can reposition it by using the X
Forms Adjust and Y Forms Adjust features. The X forms adjust controls the
position of the printing area along the length of the label. The Y forms adjust
controls the position of the printing area along the width of the label.
The following figure shows the default X and Y origins. You can control the
default X origin (top of form) with the PrintSet software or with the Test and
Service DIP switches. You can control the default Y origin with the DIP
switches only.
6-14
To enable 15 mil emulation, turn on DIP switches 4 and 5.
To enable 5 mil Advanced mode, turn off DIP switches 4 and 5.
To enable 2.5 mil Advanced mode, turn off DIP switch 4 and turn on DIP
switch 5.
The printer prints out the software configuration label. Verify that the label
states the correct mode.
printer.
Origin (Ø,Ø)
-X
Y
*FORMAT*
+Y
Leading
Edge
Direction of media from printer
NugFont
HelvC
+X
*FORMAT*
C o d e 39
3XXXU.049