Y Forms Adjust - Intermec 3400 User Manual

3400, 3440, and 3600 Bar Code Label Printer User's Manual
5. Press the Feed/Pause button.
6. Verify the X forms adjust number on the software configuration label

Y Forms Adjust

Use the Y Forms Adjust feature to control the position of the image in the
direction parallel to the printhead. See the Dot Increments DIP Switch Settings
table on page 6-10 for information on how to move the image forward a
number of dot increments. If your label is too close to one edge of the
printhead, you can adjust it using this feature.
To set the Y forms adjust
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning on the printer.
3. In the top bank of the Test and Service DIP switches, turn on switches 1, 2,
4. In the bottom bank of the Test and Service DIP switches, turn on or off the
5. Press the Feed/Pause button. The printer prints out the software
6. Verify the Y forms adjust number on the software configuration label
6-16
The printer prints out the software configuration label using the new X
forms adjust setting.
matches the number you set in Step 4.
The printer prints out the hardware configuration label and then enters
Data Line Print mode.
and 3.
appropriate DIP switches. See the Dot Increments DIP Switch Settings table
on page 6-10 to see how to set the X forms adjust forward or backward a
given number of increments.
configuration label using the new Y forms adjust setting.
matches the number you set in Step 4.
NugFont
HelvC
C o d e 39