Intermec 3400 User Manual page 39

Loading Roll Media for Straight-Through Printing
Media
Media
backing
4. Slide the supply roll retainer up to the edge of the media roll and turn the
5. Pull down on the lower media guide to allow easy access to the media path.
6. Insert the label stock through the printer mechanism as shown. Make sure
7. Release the lower media guide and adjust the edge guide to position the
8. Lower the printhead by rotating the head lift lever counterclockwise until it
9. Use PrintSet, your third-party software, or the IPL command set to
NugFont
HelvC
Head lift
lever
Edge
guide
supply roll retainer clockwise to secure.
Make sure that the edge guide slides all the way to the outer edge of the
lower media guide.
the label passes between the upper and lower media guides. The front edge
of the media should pass over the tear bar and out the front of the printer.
media firmly against the inside wall of the printer.
Note: If you are using thermal transfer media, refer to "Loading Thermal Transfer
Ribbon" later in this chapter before you finish performing this procedure.
locks.
configure the printer for the kind of media you are using (continuous or
mark label). Refer to the PrintSet online help, your third-party
documentation, or the IPL Programming Reference Manual for help.
C o d e 39
Operating the Printer
Upper
media guide
Lower
media guide
2
Media roll
Supply roll
post
Supply roll
retainer
Media
support
3XXXU.026
2-7