Intermec 3400 User Manual page 68

3400, 3440, and 3600 Bar Code Label Printer User's Manual
Printer Operation Problems (continued)
Symptom Possible Causes
Labels stop You have set the printer for
feeding through continuous label stock.
the printer.
(continued)
Media is sticking to the paper
path.
Printer slows You have incorrectly set the
down. image bands or print speed.
Printer has aborted and reset the
print speed and image bands.
Labels stick to The self-strip roller is dirty.
door or fail to
strip.
The Alert LED Printhead has overheated.
flashes and
printing stops.
Media fault. The printhead is up.
Sensor type set incorrectly.
You have incorrectly loaded the
media.
Test configuration You have incorrectly loaded the
label does not media.
print.
You have configured the printer
for self-strip media.
Media fault.
4-4
NugFont
HelvC
Solution
Use PrintSet to check the configuration settings.
If the settings are incorrect, use PrintSet to
change the settings.
Clean any extraneous material from the paper
path and clean the path thoroughly. Refer to
Chapter 3, "Maintaining the Printer."
Use PrintSet to change the image bands or print
speed settings.
Use PrintSet to change the image bands or print
speed settings.
Clean the self-strip roller. See Chapter 3,
"Maintaining the Printer."
Leave printer alone until it has time to cool
down. It will resume printing on its own.
Make sure the printhead is down. The head lift
lever should be straight up and down. Press the
Feed/Pause button to resume printing.
Configure the printer for the correct sensor for
the Print mode you are using. You can enable
self-strip and other Print modes from PrintSet.
Try reloading the media. For help, see "Loading
Media Into the Printer" in Chapter 2.
Try reloading the media. For help, see "Loading
Media Into the Printer" in Chapter 2.
Set the printer to the default configuration using
the DIP switches. For help, see "Plugging In the
Printer" in Chapter 1.
Remove media from under the label taken
sensor.
C o d e 39