Connecting The Printer To A Pc Parallel Port; Connecting Your Printer To A Network - Intermec 3400 User Manual

3400, 3440, and 3600 Bar Code Label Printer User's Manual
1-12

Connecting the Printer to a PC Parallel Port

If you are using a parallel port to communicate with your printer, you need
a Centronics parallel interface adapter installed in the printer.
a parallel cable to run between the printer and the PC.
If you did not have the parallel interface installed at the factory, a field service
technician can install the field installable option (Part No. 056830) in the I/O
board port of your printer. You can purchase a parallel cable from Intermec
(Part No. 051211) or from your local computer store. See "Centronics Parallel
Interface" in Appendix A for pin descriptions of the parallel cable connector.
To connect your printer to a PC parallel port
1. Turn the On/Off switch to the off position.
2. Plug the parallel interface connector into the parallel communications port
on the rear of the printer.
3. Plug the other end of the cable into a parallel port on the PC.

Connecting Your Printer to a Network

You can connect the printer to Novell NetWare networks, Token Ring
networks, or other TCP/IP networks. To connect the printer to a network, you
must have
a Centronics parallel interface installed in your printer.
a network interface adapter (for example, Ethernet).
If you did not have the parallel interface installed at the factory, a field service
technician can install the field installable option (Part No. 056830) in the
optional I/O board port of your printer.
* * 1233*
HelvC
FG 8pt Italic