Table of Contents
Advertisement
4.
Press [MENU/OK Button].
5.
Press [UP or DN Button] to select desired base number. Press [MENU/OK
Button] to confirm. The LCD will show "SEARCHING NUMBER".
6.
When the handset has been successfully registered, the PIN Code screen
will be displayed, PIN number should be entered.
The factory preset DEFAULT PIN Number is "0000".
7.
Press [MENU/OK Button] to confirm. The tone will be sounded and the
Base assigns a number to the Handset.
Note: When you want to add a new extension handset, you must register
the new handset to the base unit (refer to Handset Registration section).
SECURITY CODING
1.
The length of the handset security code is 16 bytes, i.e. 128 bits.
2.
The length of the base security code is 16 bytes, i.e. 128 bits.
3.
The total numbers of possible discrete digital codes are 2
to about 3.4 x 1038 different combinations.
4.
Each handset or base unit has a unique security code.
5.
Generation of the security code is by employing a sequential fixed
approach. During manufacturing, the code will be generated and
programmed into the EEPROM of the unit.
SELECTED CHANNEL
The unit may pre-scan available channels and store the detected power levels in
memory to facilitate fast selection of a channel when access is required. Since
some amount of time is required for a complete scan, the stored power level for
a selected channel may have "aged' since the measurement was taken. The unit
is therefore required to re-monitor the selected channel immediately prior to
transmission.
44
128
. This is equal
061210B-1
Hide quick links:
Advertisement
Table of Contents
