Initial Setup; Setting To Tone/Pulse Dialing Mode - Bell Phones 31070 Manual

1.
Plug the AC adaptor into a standard AC outlet.
2.
Insert the small plug into the DC 6V 250mA jack on the rear of the base
unit and Insert the small plug into the DC 6V 250mA on the rear of the
charger as shown in Figure 6.
DC 6V Jack
AC Adaptor
Plug

INITIAL SETUP

Setting to TONE or PULSE Dialing Mode:
- If your home is equipped with tone-dialing service set the TONE/PULSE
setting to TONE (default setting of your phone is TONE).
- If you have a Pulse (Rotary) dialing service, set the TONE/PULSE change the
setting to Pulse following the procedure on setting the TONE/PULSE.
If you are not sure which system you have, set the TONE/PULSE Set the phone
to TONE. Press the [TALK Button] the handset to get a dial tone, and press any
button on the [TELEPHONE Keypad] except the zero. If the dial tone continues,
it means that you do not have TONE dialing service. Press the [OFF Button] on
the handset to hang up. Set the TONE/PULSE setting to the PULSE and then try
again.
20
Base Unit
AC Outlet
6V DC
250mA
LINE LINE
AC Adaptor
(Figure 6)
061210B-1