Power Connection - Bell Phones 31070 Manual

Wall Mounting (No Standard Wall Jack)
1. Drill two holes with a vertical distance between the two marked positions
15/16"
of 3 100mm as shown in Figure 4.
3
15/1655
(100mm)
2. Drive a screw into each of the holes. Tighten them to the end of the screw
lines, only leaving the smooth part of the screw head outside the wall.
3. Place the unit onto the screws, and then slide it down firmly to fasten the
base securely.
Uninstalling Wall Mount Bracket
To remove the wall mount bracket from the base unit, pull it forward as shown
in Figure 5.

POWER CONNECTION

CAUTION: You must use a Class II, 120 Volt AC/6 Volt DC adaptor
that delivers at least 250mA for base unit. The center tip must be positive and
the plug must correctly fit the base unit's DC 6V 250mA jack.
061210B-1
(Figure 4)
(Figure 5)
19