ZyXEL Communications ZyWALL USG 2000 User Manual page 232

Chapter 10 Monitor
Table 31 Monitor > System Status > Traffic Statistics (continued)
LABEL
Interface
Traffic Type
Refresh
Flush Data
#
IP Address/
User
Direction
Amount
#
Service/Port
Protocol
Direction
232
DESCRIPTION
Select the interface from which to collect information. You can collect
information from Ethernet, VLAN, bridge, PPPoE/PPTP, and auxiliary
interfaces.
Select the type of report to display. Choices are:
Host IP Address/User - displays the IP addresses or users with the
most traffic and how much traffic has been sent to and from each one.
Service/Port - displays the most-used protocols or service ports and
the amount of traffic for each one.
Web Site Hits - displays the most-visited Web sites and how many
times each one has been visited.
Each type of report has different information in the report (below).
Click this button to update the report display.
Click this button to discard all of the screen's statistics and update the
report display.
These fields are available when the Traffic Type is Host IP Address/
User.
This field is the rank of each record. The IP addresses and users are
sorted by the amount of traffic.
This field displays the IP address or user in this record. The maximum
number of IP addresses or users in this report is indicated in
page 233.
This field indicates whether the IP address or user is sending or receiving
traffic.
Ingress- traffic is coming from the IP address or user to the ZyWALL.
Egress - traffic is going from the ZyWALL to the IP address or user.
This field displays how much traffic was sent or received from the
indicated IP address or user. If the Direction is Ingress, a red bar is
displayed; if the Direction is Egress, a blue bar is displayed. The unit of
measure is bytes, Kbytes, Mbytes or Gbytes, depending on the amount
of traffic for the particular IP address or user. The count starts over at
zero if the number of bytes passes the byte count limit. See
page 233.
These fields are available when the Traffic Type is Service/Port.
This field is the rank of each record. The protocols and service ports are
sorted by the amount of traffic.
This field displays the service and port in this record. The maximum
number of services and service ports in this report is indicated in
32 on page 233.
This field indicates what protocol the service was using.
This field indicates whether the indicated protocol or service port is
sending or receiving traffic.
Ingress - traffic is coming into the router through the interface
Egress - traffic is going out from the router through the interface
Table 32 on
Table 32 on
ZyWALL USG 2000 User's Guide
Table