ZyXEL Communications ZyWALL USG 2000 User Manual page 37

Insert the transceiver into the slot with the exposed section of PCB board facing
1
down.
Figure 4 Transceiver Installation Example
Press the transceiver firmly until it clicks into place.
2
Figure 5 Installed Transceiver
Push the end of the fiber-optic cable firmly into the transceiver until it locks into
3
place. When the other end of the fiber-optic cable is connected, check the LEDs to
verify the link status.
Figure 6 Installing the Fiber-optic Cable
Fiber-optic Cable and Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).
ZyWALL USG 2000 User's Guide
Chapter 1 Introducing the ZyWALL
37