ZyXEL Communications ZyWALL USG 2000 User Manual page 328

Unified security gateway

Hide thumbs Also See for ZyWALL USG 2000:

Table of Contents

Chapter 13 Interfaces

Figure 263 Configuration > Network > Interface > Auxiliary

Each field is described in the table below.

Table 73 Configuration > Network > Interface > Auxiliary

General Settings

Dialing Type

Initial String

Configuration

Select this to turn on the auxiliary dial up interface. The interface

does not dial out, however, unless it is part of a trunk and load-

balancing conditions are satisfied.

This field is read-only and displays the zone to which the auxiliary

interface belongs.

Enter a description of this interface. It is not used elsewhere. You can

use alphanumeric and

()+/:=?!*#@$_%-

up to 60 characters long.

Select the speed of the connection between the ZyWALL and external

Tone - select this if the telephone uses tone-based dialing.

Pulse - select this if the telephone uses pulse-based dialing.

Enter the AT command string to initialize the external modem.

the most common string, but you should check the manual for the

external modem for additional commands.

characters, and it can be

ZyWALL USG 2000 User's Guide

Troubleshooting