ZyXEL Communications ZyWALL USG 2000 User Manual page 294

Chapter 13 Interfaces
Figure 253 Configuration > Network > Interface > PPP
Each field is described in the table below.
Table 61 Configuration > Network > Interface > PPP
LABEL
User
Configuration /
System Default
Add
Edit
Remove
Activate
Inactivate
Connect
Disconnect
Object References Select an entry and click Object References to open a screen that
#
294
DESCRIPTION
The ZyWALL comes with the (non-removable) System Default PPP
interfaces pre-configured. You can create (and delete) User
Configuration PPP interfaces.
Click this to create a new user-configured PPP interface.
Double-click an entry or select it and click Edit to open a screen
where you can modify the entry's settings.
To remove a user-configured PPP interface, select it and click
Remove. The ZyWALL confirms you want to remove it before doing
so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an interface, select it and click Connect. You might use
this in testing the interface or to manually establish the connection for
a Dial-on-Demand PPPoE/PPTP interface.
To disconnect an interface, select it and click Disconnect. You might
use this in testing the interface.
shows which settings use the entry. See
for an example.
This field is a sequential value, and it is not associated with any
interface.
Section 13.3.2 on page 291
ZyWALL USG 2000 User's Guide