Repeat Playback -Automatic Cyclical Playback - Sony DSR-DR1000 Operating Instructions Manual

9
Press the j button to select "A PRESET."
SETUP MENU
OPERATIONAL FUNCTION
REPEAT FUNCTION
:OFF
REPEAT MODE
.
A
REPEAT TOP
:V.END
REPEAT END
A PRESET
B PRESET
Monitor screen
10
Press the k (OUT) button.
The A PRESET MODE screen appears. The time
code value of the current point A is displayed below
the screen title.
A PRESET MODE
A 00:00:00:00
INC/DEC : ( )( )KEY
SHIFT : ( )( )KEY
CLEAR : RESET KEY
DATA SAVE :
TO MENU :
Monitor screen
11
Use the K (IN) or k (OUT) button to select the
digit in the time code value display that you want to
change.
Each press of the button causes the digit to the left or
right to begin flashing. Holding the button down
moves the flashing digit continuously.
If you want to clear the time code value, press the
RESET button. The value is cleared to 00:00:00:00,
and the leftmost digit begins flashing.
12
Press the J (CUE) or j button to increment or
decrement the value of the flashing digit.
Each press of the button increments or decrements the
value. Holding the button down increments or
decrements the value continuously. To change other
digits, return to step 11.
13
Press the SET button to confirm the defined value.
The message "NOW SAVING..." is displayed on the
monitor screen and "Saving..." is shown in the time
counter display while the new setting is being saved in
memory.
>> A preset
Time counter display
SET KEY
MENU KEY
Note
The new setting may be lost if you power off the unit
during the saving operation. Wait until the saving
operation is completed before powering the unit off.
If you want to discard the changed value
Press the MENU button instead of pressing the SET
button to return to the menu display, then press the
MENU button again to end the menu operation
without saving the changed value into memory.
After the saving operation is completed, the monitor
screen and time counter display return to the REPEAT
FUNCTION setting display as shown in step 9.
14
To set point B, refer to steps 5 to 13. (Select
"REPEAT END" in step 5, "B POINT" in step 7, and
"B PRESET" in step 9.)
15
Press the MENU button to close the menu.
Repeat Playback —Automatic
Cyclical Playback
Proceed as follows to perform automatic cyclical playback
of recording (repeat playback) between selected start and
end points.
1
Set the desired repeat start and end points with the
REPEAT FUNCTION menu item (see page 66).
You can set points A and B as start and end points by
following the procedure described in the next section.
2
Set the REPEAT MODE menu item (see page 66) to
ON.
The REPEAT indicator lights.
3
Press the SET button to save the new setting and close
the menu.
4
Press the PLAY button.
The unit repeats playback between the repeat start and
end points set in step 1.
43
Playback