Sony DSR-DR1000 Operating Instructions Manual page 26

When in 2 CH (48 kHz) mode:
Input Audio channels on which input
connectors signals are recorded
AUDIO IN 1/3 Audio channel 1
AUDIO IN 2/4 Audio channel 2
When in 4 CH (32 kHz) mode:
2 Analog video/audio signal output section
Y/CPST
1 VIDEO OUT connectors
a VIDEO OUT connectors (BNC type)
There are the following VIDEO OUT connectors for
outputting analog video signals:
• Y/CPST
− −
• R Y/S C
− −
• B Y/S Y
• SUPER
The signals output from these connectors depend on the
setting of the VIDEO OUTPUT menu item (see page 74).
The setting is indicated by the VIDEO indicators in the
OUTPUT signal display section on the front panel.
The analog video signals that can be output from these
connectors are as follows.
When COMPOSITE/S VIDEO is selected:
Connectors
Y/CPST
R−Y/S−C
B−Y/S−Y
SUPER*
* When the CHARA. DISPLAY menu item (see page 68) is set to ON
(factory default setting), the SUPER connector outputs a composite
video signal with superimposed text information.
When Y R, B is selected:
–
Connectors
Y/CPST
R−Y/S−C
B−Y/S−Y
SUPER*
26
Location and Function of Parts
VIDEO OUT
R-Y/S-C B-Y/S-Y SUPER
Output signals
Composite signal
S−C
S−Y
Composite signal
Output signals
Y signal
R−Y signal
B−Y signal
Composite signal
Input
connectors
AUDIO IN 1/3
AUDIO IN 2/4
You can switch the audio recording mode with the REC
MODE menu item (see page 73). The selection is indicated
by the REC MODE display on the front panel.
1/3 2/4
2 AUDIO OUT 1/3 and
AUDIO OUT 2/4
connectors
* When the CHARA. DISPLAY menu item (see page 68) is set to ON
(factory default setting), the SUPER connector outputs a composite
video signal with superimposed text information.
b AUDIO OUT 1/3 and AUDIO OUT 2/4 connectors
(XLR-3 pin, male)
These connectors output analog audio signals. The output
audio channels are determined by the playback audio mode
and the setting (1/2 CH or 3/4 CH) of the AUDIO
OUTPUT menu item (see page 74) as follows.
When in 2 CH (48 kHz or 44.1 kHz) mode:
Output
connectors
AUDIO OUT 1/3 Audio channel 1 (when 1/2 CH is
AUDIO OUT 2/4 Audio channel 2 (when 1/2 CH is
When in 4 CH (32 kHz) mode:
Output
connectors
AUDIO OUT 1/3 Audio channel 1 (when 1/2 CH is
AUDIO OUT 2/4 Audio channel 2 (when 1/2 CH is
The current playback audio mode is indicated by the PB Fs
display on the front panel.
Audio channels on which input
signals are recorded
Audio channels 1 and 3
Audio channels 2 and 4
AUDIO OUT
MONITOR
3 MONITOR
connector
Output audio channels
selected) or silent (when 3/4 CH is
selected)
selected) or silent (when 3/4 CH is
selected)
Output audio channels
selected) or audio channel 3 (when 3/
4 CH is selected)
selected) or audio channel 4 (when 3/
4 CH is selected)