Sony DSR-DR1000 Operating Instructions Manual page 27

c MONITOR connector (RCA phono jack)
This connector outputs audio signals for monitoring. The
audio signals to be output from this connector can be
3 Digital signal input/output section
a DIGITAL AUDIO (AES/EBU) IN 1/2 and AUDIO
(AES/EBU) IN 3/4 connectors (BNC type)
Input digital audio signals in AES/EBU format to these
connectors.
The left connector (1/2) is for audio channels 1 and 2, and
the right connector (3/4) is for audio channels 3 and 4.
b DIGITAL AUDIO (AES/EBU) OUT 1/2 and
AUDIO (AES/EBU) OUT 3/4 connectors (BNC
type)
These connectors output digital audio signals in AES/EBU
format.
The left connector (1/2) is for audio channels 1 and 2, and
the right connector (3/4) is for audio channels 3 and 4.
c SDI IN (Serial Digital Interface input) connector
(BNC type)
This connector inputs digital video and audio signals in
SDI format. Use the VIDEO button in the video/audio
input setting section (see page 20) to select the required
input signal formats. The current input signal selections
are indicated in the INPUT signal display section (see page
19).
d SDI OUT1/OUT2 (Serial Digital Interface output
1/output 2) connectors (BNC type)
These connectors output digital video and audio signals in
SDI format.
DIGITAL AUDIO (AES/EBU)
1/2 - IN - 3/4 1/2 - OUT - 3/4
2 DIGITAL AUDIO (AES/EBU) OUT 1/2 and
AUDIO (AES/EBU) OUT 3/4 connectors
1 DIGITAL AUDIO (AES/EBU) IN 1/2 and AUDIO
(AES/EBU) IN 3/4 connectors
selected with the MONITOR SELECT button and
METER CH-1/2 3/4 button on the front panel (see page
16).
SDI
IN OUT1 OUT2
4 SDI OUT1/OUT2 connectors
3 SDI IN connector
D Time code input/output section
1 TIME CODE IN connector
TIME CODE
IN
a TIME CODE IN (time code input) connector (BNC
type)
Input externally generated SMPTE time code (for DSR-
DR1000) or EBU time code (for DSR-DR1000P) to this
connector.
b TIME CODE OUT (time code output) connector
(BNC type)
This connector outputs a time code according to the
operating state of the unit, as follows:
During playback: the playback time code
During recording: the time code generated by the internal
time code generator or the time code input to the TIME
CODE IN connector. When the EE OUT PHASE
menu item (see page 71) is set to MUTE, no time code
is output.
2 TIME CODE OUT connector
OUT
Location and Function of Parts
27