Audio problem
Symptom
The REC/PB LEVEL
control knobs do not
work.
Editing restriction
Symptom
Video cannot be edited
in insert mode.
Error Messages
This unit is provided with a self-diagnostic function that
detects internal abnormalities. When it detects an
abnormality, it outputs an error message to the monitor
screen and indicates an error code in the time counter
display.
If an error message appears, follow the direction indicated
on the monitor screen.
Alarm Messages
When operating this unit, the unit may sometimes output
alarm messages such as the one shown below to the
monitor screen and the time counter display.
100
Troubleshooting
Cause
The VARIABLE switch on the front
panel is set to PRESET.
Cause
This unit does not support insert mode.
ERROR
AN ERROR HAS BEEN
DETECTED, IFORM SERVICE
OF FOLLOWING CODE:
XX-XXX
XXXXX XXXXX XXX
XX XXXXX XXXXX
Monitor screen
ALARM
REMOTE MODE IS SELECTED.
SET REMOTE/LOCAL SWITCH
TO LOCAL.
Monitor screen
Remedy
Set the VARIABLE switch to REC when recording, or set it to
PB when playing back.
Note
To display error messages on the monitor screen, connect
the monitor to the SUPER connector, and set the CHARA.
DISPLAY menu item (see page 68) to ON (factory default
setting).
Error message
Error code
Direction
Error code
ErrorXX-XXX
Time counter display
Cause of
alarm
Direction
REMOTE!
Time counter display