How To Restore Default Settings To The Printer - Intermec PR2 User Manual

How to Restore Default Settings to the Printer

PR2 and PR3 Mobile Receipt Printer User Manual
Problems and Possible Solutions (Continued)
Problem
Printer does not print and the
Critical Error LED is off.
Printer does not print and the
Critical Error LED is on.
Print quality is too light.
Parts of the print out are missing. Clean the printhead.
The Magnetic Stripe Reader LED
flashes red one time.
When you restore factory default settings to the printer, the printer
returns to its original out-of-box state. Use one of these methods to
restore default settings to the printer:
• Use the Print and Power buttons on the printer.
• Go to the printer web page through your wireless network. You
need to know your printer IP address.
• Use PrintSet version 5.2 or later through a USB connection to your
host PC.
Chapter 3 — Troubleshoot and Maintain the Printer
Possible Solution
Try these possible solutions:
•
Make sure a battery is installed in the
printer. The printer does not print
unless a battery is installed.
•
If you are trying to print from a mobile
computer or desktop PC, make sure
you are using the correct
communication settings for your
connection.
If the Intermec Ready-to-Work™
indicator is blinking, make sure that:
•
media is loaded correctly.
•
the media cover is closed properly.
If the Ready-to-Work indicator is off,
there is a problem with the printhead or
motor. Make sure that the printhead and
motor are within the operating
temperature range.
Try these possible solutions:
•
Make sure the battery is fully charged.
•
Adjust the print contrast.
The card was not successfully read. Try
swiping the card again.
29