Page 2
The information contained herein is proprietary and is provided solely for the purpose of allowing customers to operate and service Intermec-manufactured equipment and is not to be released, reproduced, or used for any other purpose without written permission of Intermec.
• Serial or Bluetooth™ communication options Installing and Charging the Batteries The PB42 ships with two batteries. You need to fully charge the batteries before you can use the printer. You can charge the batteries inside the PB42 printer or in the CK60 battery charger.
Page 4
Battery cover latch Battery cover 2 Insert batteries into the two battery slots until they lock in place. The contact side of the battery faces the media cover. Battery cover Media cover Batteries PB42 Printer Quick Start Guide...
Loading Media You can use roll or fanfold receipt media with the PB42 printer. The PB42 ships with a sample roll of media that you can use the first time you unpack the shipping box and verify that the printer is working correctly.
Page 6
3 Insert the media between the two media supports. Make sure you load the media clockwise so that it pulls off the core from the bottom of the printer. Media supports 4 Pull out a few inches of the media. PB42 Printer Quick Start Guide...
5 Close the media cover until it latches. 6 Slide the media cover release button to the locked (right) position. Understanding the Control Panel The PB42 control panel contains two buttons and three lights. Radio button Battery lights Ready-to-Work indicator...
• PB42xxxxx.upg Where xxxxx is the version number of the firmware. To load new firmware 1 On the CK60, go to My Device > Program Files > Intermec and start FWUpgrade. 2 Select the Settings tab. 3 Select COM6 for the COM port and select the “Use Remote DCB”...