Table of Contents
Advertisement
Operation
Zoom selection
This selection is not available for Mosaic/Banner and Identity Card modes.
For normal mode, the selection principle is as described for the ZOOM key.
A5 to A4 format
You can select a 141% zoom value for an A4 printer format. The scan width therefore
corresponds to A5 format, i.e. 149 mm. The maximum length to be scanned also corresponds to
A5 format, i.e. 210 mm.
Origin selection
This selection is not available for Mosaic/Banner and Identity Card modes:
On the ADF scanner, with the sheet being centered by the margin stops, the default value xxx is
not necessarily 000: this value is now computed automatically once the output format and zoom
coefficient have been selected.
Assembled copy selection
This mode, also called "sorted copy" mode, can be used for scanning a complete document on the
ADF scanner then for printing this document n times (in "non-assembled" mode - default setting
-, each scanned page will be printed n times).
This mode only makes sense on the ADF scanner (a document shall include several pages) and
with a number of copies exceeding 1.
For an assembled copy, the document is faxed in 200 dpi fax mode then encoded (MMR coding)
and stored in the flash memory. Once the document is entirely scanned, it is printed as many times
as requested then erased from the memory.
The resulting limitations are as follows:
• fax mode scan: 216 mm in width, 1728 pixels,
• zoom forced to 100% (for any user selection).
The assembled copy selection is not available in the following cases:
• flatbed scanner: normal, Banner or Identity Card mode,
• ADF scanner with number of copies = 1,
• number of copies > 1, but with a zoom value different from 100%,
• Mosaic mode activated,
• output to a tray with A5 paper.
ZOOM
100%
ORIGIN
X=
Y=000
XXX
5-19
Advertisement
Table of Contents
