Automatic Configuration; Manual Configuration - Sagem MF 5680N User Manual

L A
OCAL REA
(
DEPENDING ON MODEL
Your terminal is a new generation machine that will be part of your local network just like a PC. Its
built-in local network access card will enable you to send documents through an SMTP/POP3 local
message server (internally or externally, depending on the settings of your message server).
To benefit from all the available network options, you should make the following settings, described in
the sections below:
• local network settings, to introduce your fax machine into your local network.
• message service settings, for all your faxes and E-mails to be automatically managed by your
message server.
Caution -
Although rather simple, network settings sometimes require a sound knowledge of your
own computer configuration. If that is administrated by anyone in your company, we recommend you
ask that person for the settings described below.

Automatic configuration

We recommend that you carry out a manual configuration of your terminal. The automatic
configuration of the local network settings may be considered, if your local network features a DHCP
or BOOTP server that can dynamically assign addresses to the peripheral devices present on the LAN.
To automatically configure the local network settings:
Choose
AUTOMATIC
or BOOTP server that can assign it its settings dynamically (the message
displayed).
Once the message
and Gateway address. If these are missing, you should carry out a manual configuration (see
below).

Manual configuration

To configure your terminal manually, you should obtain the usual information used to set a peripheral
device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
Choose
MANUAL
N
ETWORK
L
OCAL NETWORK SETTINGS
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
and press OK to confirm. The terminal scans the local network for a DHCP
has disappeared, check for the IP Address, Sub-network mask
SELF-CONF
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
and press OK to confirm.
3-12
(LAN)
SETTINGS
)
Setting your machine
is
SELF-CONF