All Leds Off; All Leds Blinking Simultaneously; Loss Of Modem/Router Ip Address - Sagem F@ST 1200 User Manual

A.3.2

All LEDs off

Check that the type of power supply available in your premises is in accordance with the
mains voltage needed to power your SAGEM F@st™ 1200.
Check that the power supply lead supplied is correctly connected at one end to the mains
power supply network.
Check that the power supply connector is correctly inserted into the corresponding port
(Power) on the SAGEM F@st™ 1200.
A.3.3

All LEDs blinking simultaneously

The modem/router has restarted in a "Recovery" degraded mode.
You must contact your Internet Service Provider (ISP).
A.4 Loss of modem/router IP address
If your modem/router's IP address is lost, communication by the configuration application with
the equipment becomes impossible.
When the configuration utility fails to set up
communication with the modem/router, the
window opposite appears.
You must enter the modem/router's IP
address then click OK to try to set up the
dialogue.
For the dialogue to be set up, the IP
addresses of your computer and your
modem/router need to be in the same
subnetwork plan.
If after a number of unsuccessful attempts the Status tab still indicates that the router is
unreachable, it will be necessary to restore your modem/router to its default IP configuration by
reverting to the factory configuration (see section A.5).
Sagem Communication document. Reproduction and disclosure prohibited
Appendix A - Troubleshooting
SAGEM F@st™ 1200 User Guide - 252336343-01
Page A-5