Installation Instructions - Sagem F@ST 1200 User Manual

2.3

Installation instructions

Environment
The SAGEM F@st™ 1200 must be installed and used inside a building.
The room temperature must not exceed 45°C.
The SAGEM F@st™ 1200 should not be exposed to strong sunlight or to strong sources of
heat.
The SAGEM F@st™ 1200 should not be placed in an environment subject to significant
steam condensation.
The SAGEM F@st™ 1200 should not be exposed to splashed water.
The SAGEM F@st™ 1200 casing must not be covered.
Power source
Use a readily accessible mains outlet, near to the equipment. The power supply lead is 2 m
long.
Arrange the power lead so as to avoid any accidental disconnection of the modem/router.
The SAGEM F@st™ 1200 is designed for connection to a TT or TN type power supply
network.
The SAGEM F@st™ 1200 is not designed to be connected to an IT type electrical
installation (power supply with independent neutral).
Protection against short circuits and leaks between phase, neutral and earth should be
provided by the electrical installation of the building. The power circuit to this equipment
should be provided with 16 A overcurrent protection and differential protection.
Maintenance
The unit must not be opened. This must be done only by personnel qualified and approved
by your Supplier.
Do not use liquid or aerosol cleaning agents.
Sagem Communication document. Reproduction and disclosure prohibited
SAGEM F@st™ 1200 User Guide - 252417101-01
2 - Description
Page 2-7