Assembly Instructions - Impex MD-4100 Owner's Manual

ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten all nuts and bolts until instructed to do so.
B.) Attach one Base Frame (#1) to the Left Rear Vertical Frame (#5). Attach the Cross Brace
(#8) to the back of the Left Rear Vertical Frame. Align the holes and secure them together
with two M10 x 2 3/8" Carriage Bolts (#67), Ø ¾" Washers (#73), and M10 Aircraft Nuts
(#75). Repeat the same procedure to install the other side.
C.) Insert six Weight Posts (#26) into the holes on the Left & Right Rear Vertical Frames.
Secure each Weight Post with one M10 x 1" Allen Bolt (#59) and Ø ¾" Washer (#73).
D.) Attach six Olympic Sleeves (#44) to the Weight Posts. Attach a Spring Clip (#50) to each
Olympic Sleeve.
7