Impex MD-4100 Owner's Manual page 17

STEP 7 (See Diagram 7)
A.) NOTE: Help of another person is strongly recommended for this step. Place the Lifting Sleeve
(#22) in between the two Safety Stop Frames (#19). Align the holes and insert the Weight Bar
(#27) all the way through. Center the bar and secure it with two M8 x 3/8" Allen Bolts (#71) on
each side.
B.) Turn the safety catch hook forward on the Lifting Sleeve to secure its position on the selected
"knuckle" on the Left & Right Front Vertical Frames (#2 & #3). Attach a Long Olympic Sleeve
(#45) to each end of the Weight Bar. Attach a Spring Clip (#50) to the Sleeve.
C.) Connect the Lat Bar (#31) to the 135" Upper Cable (#54) with one Short Chain (#47) and two
Hooks (#48).
D.) Connect the Shiver Bar (#33) to the 245" High-Low Cable (#55) with one Long Chain (#48) and
two Hooks.
E.) Attach the Decal Plate (#25) to the two Upper Support Frames (#7). Secure it with two M8 x 2
1/8" Allen Bolts (#68), four Ø 5/8" Washers (#72), and two M8 Aircraft Nuts (#74).
16