Assembly Instructions - Impex APEX AX-2109.1 Owner's Manual

ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches, two Allen
Wrenches, and one Philips Screwdriver. NOTE: It is strongly recommended this
machine to be assembled by two or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) NOTE: Do not tighten all the Nuts and Bolts until instructed to do so.
B.) Connect two Lower Guide Rods (#23) and two Upper Guide Rods (#24) with two M10
Stud Bolts (#80). Firmly thread the Rods together.
C.) Insert the Lower Guide Rods (#23) into the holes on the Rear Base Frame (#2). Secure
it with two M10 x 1" Allen Bolts (#73) and Ø ¾" Washers (#83) from the bottom.
D.) Attach the Main Base Frame (#8) to the Rear Base Frame (#2). Secure it with two M10
x 2 ½" Carriage Bolts (#79), one 4" Bracket (#30), two Ø ¾" Washers (#83), and two
M10 Aircraft Nuts (#85).
E.) Attach the Lower Vertical Frame (#3) onto the Main Base Frame (#8). Secure it with
two M10 x 2 ½" Carriage Bolts (#79), one 4 ¾" Bracket (#29), two Ø ¾" Washers (#83),
and two M10 Aircraft Nuts (#85).
F.) Attach the Leg Developer Holder (#1) to the Main Base Frame (#8) and Front Base
Plate (#15). Secure them together with two M10 x 2 ½" Carriage Bolts (#79), one 4 ¾"
Bracket (#29), two Ø ¾" Washers (#83), and two M10 Aircraft Nuts (#85).
G.) Attach the Seat Support (#16) to the Leg Developer Holder (#1). Secure it with one
M10 x 2 3/8" Allen Bolt (#71), two Ø ¾" Washers (#83), and one M10 Aircraft Nut
(#85).
H.) Attach the Seat Support (#16) to the Lower Vertical Frame (#3). Secure it with two M10
x 2 ½" Carriage Bolts (#79), one 4 ¾" Bracket (#29), two Ø ¾" Washers (#83), and two
M10 Aircraft Nuts (#85).
I.) Attach the Upper Vertical Frame (#14) to the Lower Vertical Frame (#3). Secure them
with four M10 x 2 ½" Carriage Bolts (#79), two V-shaped Brackets (#27), four Ø ¾"
Washers (#83), and four M10 Aircraft Nuts (#85).
J.) Attach the Stopper Frame (#25) to the Upper Vertical Frame (#14). Secure it with one
M10 x 2 3/8" Allen Bolt (#71) and Ø ¾" Washer (#83).
7