Impex MD-4100 Owner's Manual page 15

STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Attach the "Ball" on the 245" High-Low Cable (#55) in between two Small Pulleys (#43).
Attach the two Small Pulleys to the Sliding Pulley Bracket (#14). Secure each Small
Pulley to the Bracket with one M10 x 1 ¾" Allen Bolt (#62), two Ø ¾" Washers (#73), and
one M10 Aircraft Nut (#75).
B.) Draw the Cable upward to the top opening on the Rear Vertical Frame (#10). Attach a
Pulley (#42) to the opening. Secure it with one M10 x 2 1/8" Allen Bolt (#60), two Ø 1 1/8"
x 3/8" Pulley Bushings (#58), and one M10 Aircraft Nut (#75).
C.) Draw the Cable around the Pulley then downward to the open bracket on the back of
Rear Vertical Frame Base (#9). Install a Pulley with one M10 x 1 ¾" Allen Bolt (#62), two
Ø ¾" Washers (#73), and one M10 Aircraft Nut (#75).
D.) Draw the Cable around the Pulley then upward to the Double Floating Pulley Bracket
(#30) previously installed in Step-5. Install another Pulley with one M10 x 1 ¾" Allen Bolt
(#62), two Ø ¾" Washers (#73), and one M10 Aircraft Nut (#75). Note: After finishing the
entire cable assembly, come back to this step and adjust the tension of the cables. To
increase the tension, move up the Pulley on the Double Floating Pulley Brackets. To
decrease the tension, move the Pulley down.
E.) Draw the Cable around the Pulley then downward to the open bracket on the Rear
Vertical Frame Base (#9). Install another Pulley.
F.) Draw the Cable underneath the Pulley to the opening on the Rear Vertical Frame Base
(#9).
G.) Attach a Pulley to the opening. Attach the Foot Plate (#23) to the Rear Vertical Frame
Base. Secure the lower hole on Foot Plate to the Rear Vertical Frame Base, and the
Pulley with one M10 x 2 3/8" Allen Bolt (#61), two Ø 1" x ½" Pulley Bushings (#57), and
one M10 Aircraft Nut (#75). Secure the upper hole on the Foot Plate to the Rear Vertical
Frame Base with one M10 x 2 3/8" Carriage Bolt (#67), Ø ¾" Washer (#73), and M10
Aircraft Nut (#75).
H.) Draw the Cable around the Pulley then upward to the Sliding Pulley Bracket. Secure the
Cable to the Bracket with one M10 x 1" Allen Bolt (#59), two Ø ¾" Washers (#73), and
one M10 Aircraft Nut (#75).
14