Impex MD-4100 Owner's Manual page 9

STEP 2 (See Diagram 2)
A.) Insert one Guide Rod (#24) into the hole on the Left Base Frame (#1). Secure the bottom
with one M10 x 1" Allen Bolt (#59).
B.) Slide the Left Lower Safety Stop Frame (#20) onto the Guide Rod from the top. Slide the
Safety Stop Frame (#19) onto the Guide Rod from the top.
C.) Attach top of the Guide Rod to the tube on the Left Rear Vertical Frame (#5). Secure it
with a M8x1¾" Allen Bolt (#65), two Ø 5/8" Washers (#72), and one M8 Aircraft Nut (#74).
D.) Attach the Left Front Vertical Frame (#2) onto the Left Base Frame (#1). Secure it with two
M10 x 2 3/8" Carriage Bolts (#67), one 4 ¾" x 3" Bracket (#29), two Ø ¾" Washers (#73),
and two M10 Aircraft Nuts (#75).
E.) Attach the Left Front Vertical Frame (#2) to the Left Rear Vertical Frame (#5). Secure
them together with two M8 x ¾" Allen Bolts (#66) and Ø 5/8" Washers (#72).
F.) Attach the Left Bar Holder (#17) and Left Safety Catch (#15) onto the Left Front Vertical
Frame (#2).
G.) Repeat Procedures A to F above to install the other side.
8