Optional Blower - Jøtul GF 100 DV II Nordic QT; GF 200 DV II Lillehammer Installation And Operation Instructions Manual

138003_Rev_K / 7.29.10

Optional Blower # 155631

CONNECT THE GAS SUPPLY TO THE
STOVE BEFORE INSTALLING THIS
BLOWER. USE A 90° ELBOW OFF THE
GAS VALVE TO CREATE ADEQUATE
GAS LINE CLEARANCE.
 THIS BLOWER MUST BE ELECTRICALLY
GROUNDED IN ACCORDANCE WITH LO-
CAL CODES OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE CURRENT ANSI/NFPA 70,
NATIONAL ELECTRICAL CODE OR CSA C22.1-
CANADIAN ELECTRICAL CODE.
 THIS UNIT IS SUPPLIED WITH A THREE-
PRONG (GROUNDING) PLUG FOR PRO-
TECTION AGAINST SHOCK HAZARD AND
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THE PLUG.
 ALWAYS DISCONNECT THE POWER SUPPLY
WHEN PERFORMING ANY SERVICE ON THE
FIREPLACE INSERT.
Installation
1. Unpack and check the contents
of the blower kit. Contact your
dealer if any damage is evident
or parts are missing. See fig. 35.
2. Attach the Control Box to the
Snapstat Bracket using two
#8 x 1/2" sheet metal screws.
As shown in fig. 35, use the pair
of mounting holes appropriate
for your stove.
3. Attach the Control Box to the
studs located underneath the
stove in the middle of the fire-
box floor using the two M6 hex
nuts and a 10 mm socket driver
or wrench. See fig. 36.
4. Attach the Blower to the stove.
24
Contents
1. Blower
2. Snapstat Wire Harness
3. Control Box
4. Snapstat Bracket
5. Rheostat Knob
6. Snapstat
7. Mounting Bracket (GF100 DV II ONLY)
8. M6 Flange Nuts, (2)
9. M6 x 12 Hex Bolts, (2)
10. #8 x 1/2" Sheet metal screw, (4)
Upper Holes
for GF100
DV II
Lower Holes
for GF200
DV II
10
Figure 35. Blower Kit Components
MANUAL
OFF
AUTO
BLOWER
Figure 36. Attach Control Switch Box.
6
4
5
3
8
Snapstat
Secure with
two Hex Head
Flange Nuts
Tools Required
• 1/4" socket driver
• 10 mm socket
driver or wrench
10
7
10
2
9
1