Jøtul GF 100 DV II Nordic QT; GF 200 DV II Lillehammer Installation And Operation Instructions Manual page 23

Glass and Gasket Replacement
Only Use Replacement Kit 155599.
1. Use a small screwdriver to pry the four retainer clips
off of the glass frame. See fig. 33.
2. Peel away all remnants of the old gasket material
and clean any adhesive residue off the glass.
3. Peel the paper backing off the replacement gasket to
expose the adhesive.
4. Apply the gasket to the panel, wrapping the adhesive
side down around the panel edge. See fig. 34.
5. Insert the gasketed glass panel into the frame and
press the retainer clips back into place as shown.
Always replace any damaged or broken parts with
JØTUL AUTHORIZED PARTS ONLY. These are available
through your Jøtul dealer. Never use any substitute parts
on your stove.
With proper care and maintenance your appliance
will provide you with many years of enjoyment. If you ex-
perience any problems or inconsistency with your stove,
contact your authorized Jøtul dealer for assistance.
Figure 33. Removal and replacement of the glass panel.
Figure 34. Wrap the gasket around the glass panel.
Enamel Care and Maintenance
• Do not attempt to clean hot enamel surfaces. Clean
only cold surfaces with a soft damp cloth and polish
with a clean dry cloth.
• Do not use soapy or abrasive solutions. These can
cause stains. Coffee, tea, and fruit juices will also
stain enamel.
• Avoid contacting the enamel with other metal ob-
jects. Trivets, kettles, or pots can damage the enamel.
• Small chips may be repaired with Jøtul Enamel Touch-
up paints available from your Jøtul dealer.
KEEP THIS MANUAL FOR REFERENCE AND MAKE IT
AVAILABLE TO ANYONE USING OR SERVICING THE
STOVE.
138003_Rev_K / 7.29.10
23