ZyXEL Communications AMG1001-T Series User Manual page 89

Table 34 Access Management > Filter (IP/MAC) (continued)
LABEL
Rule Type
Active
Source IP Address
Subnet Mask
Port Number
Destination IP Address
Subnet Mask
Port Number
Protocol
MAC Address
Rule Unmatched
IP Filter Listing
IP Filter Set Index
Interface
Direction
#
Active
Src Address/Mask
Dest IP/Mask
Src Port
Dest Port
Protocol
Unmatched
SAVE
DELETE
CANCEL
AMG1001-T/AMG1011-T Series User's Guide
DESCRIPTION
Select IP or MAC type to configure the rule.
Use the IP Filter to block traffic by IP addresses.
Use the MAC Filter to block traffic by MAC address.
Use this field to enable or disable the rule.
Enter the source IP address of the packets you wish to filter. This field is ignored
if it is 0.0.0.0.
Enter the IP subnet mask for the source IP address
Enter the source port of the packets that you wish to filter. The range of this field
is 0 to 65535. This field is ignored if it is 0.
Enter the destination IP address of the packets you wish to filter. This field is
ignored if it is 0.0.0.0.
Enter the IP subnet mask for the destination IP address.
Enter the destination port of the packets that you wish to filter. The range of this
field is 0 to 65535. This field is ignored if it is 0.
Select ICMP, TCP or UDP for the upper layer protocol.
This field is only available when you select MAC in the Rule Type field.
Enter the MAC address of the packets you wish to filter.
Select the action for a packet not matching the rule.
Select Forward to forward traffic immediately and skip checking the remaining
rules. Select Next to check the next rule.
Select the index number of the filter set from the drop-down list box.
This is the interface that the filter set applies to.
The filter set applies to this traffic direction.
This is the index number of the rule in a filter set.
This field shows whether the rule is activated.
This is the source IP address and subnet mask when you select IP as the rule
type.
This is the MAC address when you select MAC as the rule type.
This is the destination IP address and subnet mask.
This is the source port number.
This is the destination port number.
This is the upper layer protocol.
When a packet doesn't match the rule, this is the action the AMG1001-T/
AMG1011-T takes on the packet.
Click this to save your changes.
Click this to remove the filter rule.
Click this to restore your previously saved settings.
Chapter 15 Filters
89