The Reset Button; Using The Reset Button; Usb Port (Amg1011-T Only); Installing The Usb Driver In Windows - ZyXEL Communications AMG1001-T Series User Manual

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to "1234".

1.6.1 Using the Reset Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.

1.7 USB Port (AMG1011-T Only)

The USB port is useful if y ou have an USB-enabled computer that does not have a network interface
card for attaching to your Ethernet network. See the following sections for USB driver installation
procedures in your operating system.
System Requirements
• Windows XP, Windows Vista, Windows 7 or Windows 8
• An available USB port
Note: Install the USB driver before you connect the AMG1001-T/AMG1011-T to the USB
port.

1.7.1 Installing the USB Driver in Windows

Save your work and close all applications.
1
Insert the included CD. The CD automatically runs and the main screen displays.
2
Click the Setup icon on the main screen.
3
Select the Windows version of your operating system.
4
An install warning may appear in the Windows Vista OS. Click Allow to continue.
5
AMG1001-T/AMG1011-T Series User's Guide
Chapter 1 Introducing the AMG1001-T/AMG1011-T
15